Application
Applicable as a bracing element for single-arm cantilevers in conjunction with siFramo 80 section, and for the knee-brace reinforcing of siFramo 80 frame constructions. The pivot can be installed with angles from 25° to 155°.
Installation
Attachment of Joint GE F 80 to Beam Section TP F 80 by means of 4 Self Forming Screws FLS F at the base plate. The support profile TP F 80 plugged onto the octagon is also attached by means of 4 Self Forming Screws, so 8 Self Forming Screws are necessary in total. The cutting length of the support profile can be determined by the table below-mentioned. After installation at the desired angle the screws have to be tightened with 40 Nm.
Technical Data
Material: Steel, HCP.
| Type | Height H [mm] | Length L [mm] | Width B [mm] | Angle α |
|---|---|---|---|---|
| GE F 80 - 80 | 140 | 80 | 80 | 25° - 155° |
Cutting length c of support profile between two joints:
| b [mm] 1000 |
b [mm] 1500 |
b [mm] 2000 |
b [mm] 2500 |
b [mm] 3000 |
|
| α | c [mm] | c [mm] | c [mm] | c [mm] | c[mm] |
| 25° | 2155 | 3340 | 4525 | 5710 | 6890 |
| 30° | 1810 | 2810 | 3810 | 4810 | 5810 |
| 35° | 1565 | 2435 | 3305 | 4180 | 5050 |
| 40° | 1380 | 2160 | 2940 | 3720 | 4495 |
| 45° | 1245 | 1955 | 2660 | 3370 | 4075 |
| 50° | 1145 | 1800 | 2450 | 3100 | 3755 |
| 55° | 1060 | 1670 | 2285 | 2895 | 3505 |
| 60° | 1000 | 1580 | 2155 | 2730 | 3310 |
| 65° | 950 | 1500 | 2055 | 2605 | 3155 |
a: vertical length from centerline of joint to bottom of profile at connection
b: horizontal length of cantilever from connection to centerline of joint
c: cutting length of support profile between two joints
α: angle at the opposite of the vertical bracing
= Sold by pack
-
- 2.1
- 1
- 113835
- Registrati
-
-
GE F 80
- 3
- 1
- 113834
- Registrati
-
