PIVOT JOINT GE F 80

PIVOT JOINT GE F 80

Download PDF
Information request

Application

Applicable as a bracing element for single-arm cantilevers in conjunction with siFramo 80 section, and for the knee-brace reinforcing of siFramo 80 frame constructions. The pivot can be installed with angles from 25° to 155°.

 

Installation

Attachment of Joint GE F 80 to Beam Section TP F 80 by means of 4 Self Forming Screws FLS F at the base plate. The support profile TP F 80 plugged onto the octagon is also attached by means of 4 Self Forming Screws, so 8 Self Forming Screws are necessary in total. The cutting length of the support profile can be determined by the table below-mentioned. After installation at the desired angle the screws have to be tightened with 40 Nm.

 

Technical Data

Material: Steel, HCP.

TypeHeight H
[mm]		Length L
[mm]		Width B
[mm]		Angle α
GE F 80 - 80 140 80 80 25° - 155°


Cutting length c of support profile between two joints:

b [mm]
1000		 b [mm]
1500		 b [mm]
2000		 b [mm]
2500		 b [mm]
3000
α c [mm] c [mm] c [mm] c [mm] c[mm]
25° 2155 3340 4525 5710 6890
30° 1810 2810 3810 4810 5810
35° 1565 2435 3305 4180 5050
40° 1380 2160 2940 3720 4495
45° 1245 1955 2660 3370 4075
50° 1145 1800 2450 3100 3755
55° 1060 1670 2285 2895 3505
60° 1000 1580 2155 2730 3310
65° 950 1500 2055 2605 3155

a: vertical length from centerline of joint to bottom of profile at connection

b: horizontal length of cantilever from connection to centerline of joint

c: cutting length of support profile between two joints

α: angle at the opposite of the vertical bracing

PIVOT JOINT GE F 80
PIVOT JOINT GE F 80
PIVOT JOINT GE F 80
Code Name Weight Number of pieces
113834 GE F 80 3 1 Information request
113835 2.10 1 Information request